Dolly Installation

INSTALLING DOLLIES

The first step for setting up dollies is to set the dolly axles to the required length for the casualty being towed. This length can be determined by using a tape measure or by laying the axle under the casualty and adjusting the axle. Place axles in front and behind the tires. The dolly frame can then be attached to axles by disengaging any locks and placing the axles in the axle cradles. Be sure that the dolly is parallel to the casualty to avoid damage the dolly wheels. Rotate the tires into position until locked and repeat on the other side of the casualty. The dolly must then be secured to the vehicle, usually via the wheels.

WreckMaster recommends using a motorcycle strap with a rachet to secure the wheels to the dolly. After a final inspection, the dollies are now ready to be used.

INSTALLING DOLLIES STEP-BY-STEP

STEP 1

Get the wrecker into position, extend the wheel lift, attach the wheel grid, and lift the casualty.

STEP 2

Retrieve the dollies from the wrecker and set the cross tubes to the correct vehicle width.

STEP 3

Attach the cross tubes to the dolly on both sides of the casualty.

STEP 4

Use the load bar to raise the dollies into the upright position and secure the safety latches.

STEP 5

Repeat on the opposite side of the casualty.

STEP 6

Secure the casulaty to the dollies with straps.

STEP 7

After securing the steering wheel, adjusting the wheel lift to towing height, and attaching tow lights, the casualty is ready to go.